Installing The Rapidrails Mounting Rails - Dell PowerVault 220S Guide D'installation

Place a mark 13.3 centimeters (5.25 inches) above the original mark (or count up nine
2
holes in a rack that meets EIA-310 standards) and mark the rack's front vertical rails
with a felt-tipped marker or place masking tape where the system's upper edge will be
located (see Figure 1-4).
F i g u r e 1 - 4 . M a r k i n g t h e V e r t i c a l R a i l s
3-U (5.25 inches) between
rails (drawing is not to
scale)
tape marking locations for
top and bottom of system

Installing the RapidRails Mounting Rails

NOTE: If you are installing VersaRails rails, see "Installing the VersaRails Mounting Rails."
At the front of the rack cabinet, position one of the mounting rails so that its
1
mounting-bracket flange fits between the marks or tape you placed on the rack (see
Figure 1-5).
Align the rail mounting-bracket flange (on the front of the rail) with the square holes
2
in the front vertical rails (see Figure 1-5).
Ra c k In s ta l la ti on Gu i d e
1-7