Dell PowerVault 220S Guide D'installation page 16

To remove the tower system base:
5
a
b
c
F i g u r e 1 - 8 .
round covers (2)
hex-socket
cap screw (4)
flat washer (4)
base
1-12 Rac k I nst allat io n G uide
Lay the system on its right side.
Use a 3/16-inch hex-head (Allen) wrench to remove the two hex-socket cap screws
and flat washers from the base of the tower chassis
Remove the base and set it aside (see Figure 1-8).
R e m o v i n g t h e To w e r S y s t e m C o v e r
left and right covers