Fm Operation - auna iTuner 320 BT Mode D'emploi

EN
FM
radio
FM Radi o
58

FM OPERATION

Switching from DAB to FM Mode
To switch the unit to FM mode, press the MODE button repeatedly to switch
to FM mode. The display will show the frequency.
Auto Scan
Press and hold the TUNING buttons to start searching for a station.
Note: The search may not stop at a station with a very week signal.
Manual Tuning
To search for FM stations manually, press the TUNING buttons repeatedly
until your desired frequency is reached.
Note: With FM radio, it may be necessary to fine tune each station by
pressing the TUNING buttons repeatedly. Each press will adjust the
frequency by 0.05 MHz. If reception is still poor, adjust the position of the
aerial or try moving the radio to another location.
Scan Setting
1. Press the MENU button to access FM menu.
2. Press the PRESET 
SELECT button to confirm.
/
3. Press the   buttons to select YES to receive Strong stations only and
then press the SELECT button to confirm.
Audio Setting
Press the MONO/ST. button on the remote control to toggle between the
Stereo or Mono selection.
Alternatively:
1. Press the MENU button to access the main menu.
/
2. Press the   buttons to select Audio setting and press the SELECT
button to confirm.
/
3. Press the   buttons to select YES to listen in Mono only or NO to let
the unit select Stereo or Mono automatically.
4. Press the SELECT button to confirm.
/
 buttons to select Scan setting and then press the