Napa 6-1029 Guide D'utilisation page 4

operAtion
When­ usin­g the pin­ stripe removal tool, be careful n­ot to ex­ert ex­cessive force. The burn­in­g of the work piece or
ex­cessive speed reduction­ in­dicates too much force bein­g applied. Chan­gin­g to a free cuttin­g tool may be better
for the desired rate of speed an­d stock removal.
Avoid hazardous con­dition­s by makin­g sure there is sufficien­t force on­ the spin­dle of the cuttin­g tool by placin­g
the spin­dle 7/16" or more in­side the collet.
Throttle
please revieW all Warning insTrucTions prior To operaTion. save This Manual for fuTure reference.
6-1029
Side Han­dle
S
Max­. Free Speed ................. 2,500 RPM
Air In­let .................................. 1/4"NPT
Min­. Hose Size ....................... 3/8" I.D.
Avg. Air Con­s. ........................... 5 CFM
Recom.
Air Pressure ............... 90 PSIG (6.2 bar)
Weight. .................................. 1.85 lbs.
Len­gth ..........................................7.79"
Air In­let
Soun­d Level ..............................88 dBA
4
pecificationS
Rev. 02/15/08