Publicité
English
Other hot beverage
Steam dispensing
Put a cup with the beverage you wish to heat under the right or left
steam nozzle (6).
Completely immerse the steam nozzle in the beverage.
Push the steam control lever (7) upward, allow the beverage to heat to
the desired temperature, then lower the control lever.
Heating milk for frothy coffee (cappuccino)
Use a tall narrow jug and fill it up to about the half-way mark. Then plunge
the steam jet pipe (6) into the milk.
Gradually open up the steam tap (7) and heat the milk for a few seconds.
When the required amount of froth has been made and the temperature
is sufficiently high, stop the flow of steam by turning knob (7) the other
way (towards “0”).
When the steam jet pipe (6) is no longer required, clean it thoroughly
with a sponge and a clean cloth.
Dispensing hot water
Put a cup or other container under the hot water spout (8).
Lift lever (9) to dispense the desired amount of hot water.
Stop the dispensing by put lever (9) back into its original position.
Note: At the conclusion of each steam dispensing phase,
clean the inside of the steam nozzle as follows:
Turn the nozzle towards the cup tray and carefully
activate steam dispensing at least once.
Programming the coffee measures
How to access the programming function
To enter the programming mode, press STOP/progr button (18) and
keep it pressed for a few seconds; the buzzer sounds intermittently.
To exit the programming mode, after programming the various drinks,
press STOP/progr button (18) again.
“ Before programming the coffee dispensing push buttons fill
!
the filter holder with the correct serving of ground coffee.
Don’t use coffee grouts for programming servings. ”
Fit and tighten the filter holder (10) on the coffee dispenser unit, positioning
the cup (or cups) under the nozzle (or nozzles) of the filter holder (10).
Press (and keep momentarily pressed) the coffee dispensing push button
(16, 17, 19 or 20) corresponding to the required serving to be programmed.
When the amount of coffee in the cup reaches the required level, release
the coffee dispensing push button.
Repeat the above operations for the other coffee push buttons.
Note: if you make a programming mistake, use a new dose of ground
coffee and repeat the operation.
Water level control of boiler
The machine is fitted with a series of automatic level control devices to
keep the water in the boiler at a pre-set level.
Filling the boiler with water using the manual service tap
This function should be used only if the electronic level control devices
are not working correctly.
Press the filling lever (5), taking care not to exceed the MAX. level on the
boiler water level indicator (13).
7
8
19
18
13
English
16
10
17
20
9
6
5
Publicité
