Remote Diagnostics; Data Protection - Siemens EQ900 Manuel D'utilisation

en Home Connect
You can find the Home Connect set-
tings in the basic settings for your ap-
pliance. Which settings the display
shows will depend on whether
Overview of the Home Connect settings
Here you can find an overview of the "Home Connect" settings and network set-
tings.
Basic setting
WiFi connection
Remote start
Add mobile
device
Network informa-
tion
Delete
Software update
11.3 Remote diagnostics
Customer Service can use Remote
Diagnostics to access your appliance
if you contact them, have your appli-
ance connected to the Home Con-
nect server and if Remote Dia-
gnostics is available in the country in
which you are using the appliance.
Tip: For further information and de-
tails about the availability of Remote
Diagnostics in your country, please
visit the service/support section of
your local website: www.home-con-
nect.com
24
Selection
On
Off
On
Off
-
-
-
-
Home Connect has been set up and
whether the appliance is connected
to your home network.
Description
Switch off the wireless module during
long absences or to save energy.
Note: In networked standby mode
your appliance requires max. 2 W.
Switch remote start on the appliance
on and off.
Note: With the "Home Connect" app
only switch-off is possible.
Connect the appliance to the "Home
Connect" app or additional accounts.
Display network information and appli-
ance information.
Note: You cannot operate your appli-
ance via the "Home Connect" app
without a network connection.
Note: This setting is only available
with a software update.
11.4 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the Home Connect
server (initial registration):
¡ Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).