Start-Up/Shut Down; Start-Up; Filling Self-Priming Pumps With Water; Checking How Easily The Pump Rotates - BADU Eco Motion Fiche Technique

Pos: 113 /Technische Dokumentation/Betriebsanleitung/Inbetriebnahme/ZIS 40/Inbetriebnahme/Außerbetriebnahme @ 3\mod_1445236048158_370.docx @ 49297 @ 1 @ 1
6

Start-up/shut down

Pos: 114 /Technische Dokumentation/Betriebsanleitung/Inbetriebnahme/Inbetriebnahme @ 0\mod_1427956937430_370.docx @ 27298 @ 2 @ 1
6.1

Start-up

NOTICE
The pump/unit can be damaged if it runs dry!
 Ensure that the pump/unit is always full of water. This also
applies to checking the rotation direction.
Pos: 115 /Technische Dokumentation/Betriebsanleitung/Inbetriebnahme/Selbstansaugende Pumpe mit Wasser füllen @ 0\mod_1427959830385_370.docx @ 27313 @ 3 @ 1
6.1.1

Filling self-priming pumps with water

1. Remove the lid. See point 8.1 on page 25.
NOTICE
High concentrations water treatment chemicals can damage the
pump!
 Do not place water treatment products, particularly in tablet
form into the strainer basket.
2. Fill the pump with clean water up to the inlet connection.
NOTICE
Tightening the lid too tight when using the opening device will
make it difficult to re-open the lid.
 Only apply normal manual force!
3. Replace and tighten the lid.
Pos: 116 /Technische Dokumentation/Betriebsanleitung/Inbetriebnahme/Pumpe auf Leichtgängigkeit prüfen @ 0\mod_1427961952256_370.docx @ 27328 @ 3 @ 1
6.1.2

Checking how easily the pump rotates

After longer idle periods, the pump must be checked for how
easily it rotates while it is switched off.
 Place a screwdriver in the groove on the end of the motor
shaft on the fan side and turn it.
– or –
If there is not a groove on the end of the motor shaft:

Remove the fan cover and turn the fan wheel manually in the
motor rotation direction.
Pos: 117 /Technische Dokumentation/Allgemeine Module/#### Seitenumbruch #### @ 0\mod_1426069111812_0.docx @ 891 @ @ 1
04|2017
Start-up/shut down
EN 21