Kodak STEP Guide De L'utilisateur page 6

Your camera will automatically flash and
auto focus for every photo. A lens cap has
been included to keep your lens clean and
scratchfree. Don't forget to use it!
Printing
The camera instantly prints every photo for
you when photo paper is loaded. You can
take up to three photos while the camera is
printing. After three pictures, your camera
will not capture any more photos until
printing is finished.
Reprinting
– To reprint the last photo taken,
press and hold both the shutter button
10 | EN
and color mode selector for three
seconds. You'll hear a beep; the LED will
blink white; then your reprint will emerge
from the photo slot.
Photo Paper
Inserting Photo Paper
1. Slide the latch on the paper tray and open
the door.
2. Slide the entire pack of KODAK ZINK
Photo Paper into the paper tray. Make
sure the KODAK ZINK Color Calibration
Sheet is placed and loaded with the bar
code face down. Shiny side of paper
faces up.
3. Close the paper tray door.
The KODAK ZINK Color Calibration Sheet
will eject when you take a picture, then your
photo will print.
For bright, sharp instant photos that come
out dry to the touch and ready to peel and
stick, we recommend KODAK ZINK Photo
Paper.
Refilling Photo Paper
– When the last photo paper sheet is used,
the LED next to the paper icon on the
back of your camera will glow red. You
can now safely reload printing paper into
your camera.
Paper Do's & Don'ts
– Don't add more paper if the paper
compartment is not completely empty.
– Don't fill the paper compartment with
more than one 10-pack of KODAK ZINK
Photo Paper. Filling over 10 sheets can
damage the printer.
– Do avoid bending the KODAK ZINK Photo
Paper.
– Do hold the paper by its edges. Avoid
touching the surface with your fingers.
If there is a paper jam, if you insert the
EN | 11