Floor And Carpet; Quick Start - shark V2940C Manuel Du Propriétaire

QUICK START

b
Fig. 1
ASSEMBLE
1 Insert the smaller end of the
lower handle into the top of
the unit. Push until firmly in
place. Insert the lower handle
extension tube (the shortest of
the three tubes) into the lower
handle (a). Then assemble the
other two extension tubes and
insert the assembly into the
lower handle extension tube (b).
Now attach the upper handle to
the top extension tube. (Fig. 1)
IMPORTANT: Before you can start using your new cordless
floor and carpet sweeper, charge it for 20 hours.
NOTE: The charging adapter will be shipped inside the
packaging.
a
Fig. 3
CLEAN
2 Pull back on the handle and
press lightly on the body of the
unit with your foot to engage the
steering. (Fig. 2)
3 Using your foot, press the
power button and push the unit
forward over the surface you
wish to clean. (Fig. 3)
4 Press the speed button on the
right with your foot to change
the speeds. One light indicates
the speed optimized to clean
bare floors and two lights
indicate the speed optimized to
clean carpets and larger debris
on bare floors. (Fig. 4)
Fig. 2
Fig. 4
EMPTY
5 When you're finished cleaning,
pull the dust container straight
out from the side. (Fig. 5)
NOTE: Be careful not to
accidentally turn the unit on.
6 Empty dust container contents.
(Fig. 6) If desired, you may
rinse with water to clean
the dust container - but dry
thoroughly before replacing.
When finished, replace the dust
container.
www.sharkclean.com
English
Fig. 5
Fig. 6
5