Axis Q1615-E Mk II Mode D'emploi page 25

3. Keep the control button pressed for 15–30 seconds until the status LED indicator flashes
amber.
4. Release the control button. The process is complete when the status LED indicator turns
green. The product has been reset to the factory default settings. If no DHCP server is
available on the network, the default IP address is 192.168.0.90.
5. Use the installation and management software tools to assign an IP address, set the
password, and access the video stream.
The installation and management software tools are available from the support pages
on axis.com/support.
It is also possible to reset parameters to factory default through the web interface. Go to Settings
> System > Maintenance and click Default.
Further information
• For the latest version of this document, see axis.com
• The user manual is available at axis.com
• To check if there is updated firmware available for your device, see axis.com/support
• For useful online trainings and webinars, see axis.com/academy
Warranty information
For information about Axis' product warranty and thereto related information, go to
axis.com/warranty.
AXIS Q1615-E Mk II Network Camera
25
EN