Axis Q1615-E Mk II Mode D'emploi page 12

AXIS Q1615-E Mk II Network Camera
6
Bottom cover
7
Bottom cover screws (4x)
8
Grounding cable
9
Wall mount
10 Bracket adjustment screw
LED Indicators
Note
• The Status LED can be configured to be unlit during normal operation. To configure,
go to Settings > System > Plain config.
• The Status LED can be configured to flash while an event is active.
• The Status LED can be configured to flash for identifying the unit. Go to Settings >
System > Plain config.
Status LED
Green
Amber
Red
Note
The Network LED can be disabled so that it does not flash when there is network traffic. To
configure, go to Settings > System > Plain config.
Network LED
Green
Amber
Unlit
Note
The Power LED can be configured to be unlit during normal operation. To configure, go to
Settings > System > Plain config.
Power LED
Green
Amber
Indication
Steady green for normal operation.
Steady during startup. Flashes when restoring settings.
Firmware upgrade failure.
Indication
Steady for connection to a 100 Mbit/s network. Flashes for
network activity.
Steady for connection to a 10 Mbit/s network. Flashes for
network activity.
No network connection.
Indication
Normal operation.
Flashes green/amber during firmware upgrade.
12