Use; Counter-Instructions; Transport; Packaging - Rancilio ROCKY Emploi Et Entretien

4. USE

The machine has been designed to grind coffee.
Any other use is to be considered unsuitable and
therefore dangerous.
The user must always follow the indications contained
in this manual. In the case of a failure or if the machine
is not working properly, switch it off and do not attempt
any direct repair.
Contact the assistance service.
The user must not:
● put his hands under the ground coffee container;
● transport the machine or carry out maintenance
operations with the plug connected and when the
machine is warm;
● pull the supply cable in order to disconnect the
machine from the supply network;
● use the machine if the supply cable is damaged;
● touch the machine with wet or damp hands or feet;
● wash the machine with water or vapour jet;
● dip the machine in water or other liquid;
● use the machine when there are children in its
proximity;
● allow the machine to be used by children or
incapable person;
● obstruct the suction or heat despersal grilles with
cloths, ect.;
● leave the side doors open;
● place container with liquid on the machine
It is forbidden to install or use the machine if
it is be wet or damp.
It is always necessary to request an accurate
check by qualified personnel in order to find
any possible damages to the electric
components.

4.1. Counter-instructions

This machine may be used only for the purposes for
which it was designed. It cannot be used to dispense
products other than coffee or any non food products.
The manufacturer cannot be held responsible
for any damage caused by unsuitable,
erroneous or irrational use of the machine.

5. TRANSPORT

5.1. Packaging

The machine must always be transported in a correct
position following the instructions on the cardboard
box.
Do not turn over the machine or lay it down on
a side.
30
The box also contains separate accessories and a
technical documentation which must be saved for
further consultations.
● Open the top part of the packaging, remove the
accessories and then remove the machine from its
packaging.
● Check if the machine, the accessories, the electric
cable and the plug are in perfect condition. Should
one of these parts be damaged, immediately
contact the retailer.
The packing elements (plastic bags,
expanded polystyrene, nails, cardboard, etc.)
must not be left within reach of children as
they are potential sources of danger.
Do not dispose of the packing elements in
the environment; consign them to firms
authorized for their disposal,

6. INSTALLATION

The machine is delivered ready to be installed in
accordance to the label data.
Ensure that the electrical supply system has the same
features as the machine.
The electrical supply system must be equipped
with a life saving device or a general automatic
switch with an efficient earthing system.
Should there be no electrical protection
element, have a single-pole switch installed
by qualified personnel, as envisaged by the
current safety regulations with a contact
opening distance of either equivalent or over
3 mm.
The earthing of the appliance is
compulsory.
The constructor declines all responsibility
in the event of the failure to respect the
accident prevention norms.
Take care not to damage the supply cable by
pressing, or crushing.
Do not disconnect the machine by pulling the
cable, but detach by gripping the plug.
The machine is not to be positioned in any niches or
similar difficult positions in order to prevent problems
relating to operation, supply and maintenance.
● The machine must be placed on a completely level
surface, that is both dry and sufficiently stable and
at a height of 80 cm from the ground.
● Position the machine and connect the plug to the
power socket.