Vortice Air Door Série Notice D'emploi Et D'entretien page 12

ENGLISH
• install the appliance at least 2.3 m from the floor. (fig.
6);
6 6
• If the access area is larger than the appliance, we
recommend installing two or more units in parallel; in
this case, leave a gap of 20-40 mm between one unit
and the other (fig.7);
7 7
• do not leave gaps between the appliance and the
wall. In case of ceiling installation, use the brackets
(NOT included) (fig. 8);
8 8
12
20 ~ 40 mm
• do not install the appliance in places where it could
come into contact with water, vapours, explosive
gases or corrosive substances (fig.9);
9 9
Mounting
Remove the mounting plate by loosening the screws
fixed to the back of the central body (fig.10).
10 10
Mounting plate
Fixing screw
If you want to install door opening sensors (not
supplied), break the drilled hole at the back of the
machine. Pull out the sensor connection cables. (Fig.
10a) S = Sensor
10a 10a
s