Installation; General Information; Safety Precautions; Stove Installation Site - Palazzetti ECOFIRE GINGER Généralités - Avertissements - Installation - Entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

5 INSTALLATION

5.1 GENERAL INFORMATION

The following paragraphs provide instructions that
must be complied with in order to ensure maximum
The following instructions are however subordinate
to compliance with any national, regional and local
laws and standards in force in the country where
the product is installed.
in compliance with EN 10683.

5.2 SAFETY PRECAUTIONS

Responsibility for work carried out in the place
where the stove is installed lies with the user;
the user is also responsible for making sure the
installation checks are completed.
The user must abide by all local, national and
European safety requirements.
suitable load-bearing capacity.
The stove assembly and dismantling instructions
are reserved exclusively for specialist technicians.
Users should always contact our service centre
technicians.
Before having work performed by other technical
personnel
verify
competence. Before starting to assemble or
dismantle the stove, the installer must heed the
A) do not work in adverse conditions;
B)
and make sure that personal protective
equipment is in perfectly working order;
C) always wear safety gloves;
D) always wear safety shoes;
E) always use electrically insulated tools;
F) make sure that the area being used for assembly
and dismantling is clear of any obstacles.
22
their
effective
technical

5.3 STOVE INSTALLATION SITE

The enclosed "Product technical details" show the
minimum clearances from combustible materials
and objects expressed in centimetres that must
be observed when positioning the stove; for non-
halved.
to excessive heat.
wood, parquet, linoleum, laminates or carpets
base underneath stove. Such base may be made
from steel, slate, glass or stone and must cover
at the front.
The manufacturer declines all liability for any
alterations to the characteristics of the material
base.
Any elements made from wood (e.g. beams) or
other combustible material located near the stove
Leave enough clearance for maintenance work, and
at least 20 cm on the left side to access the power
switch located on the rear of the stove.
materials (x) is observed, as shown on the pipes
Pi
Pp = Protezione pavimento
Pi
Pp

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ecofire elisabethEcofire noah

Table des Matières