Publicité
Les langues disponibles
Les langues disponibles
(The operation timer is fed during the whole opening phase and during closing, after it has had the consent from the second leaf delay timer).
When there is only one motor connected, put trimmer P2 in the minimum count position, and the motor clutch will slide for a second longer during closing than
during opening.
N.B.: IF ONLY ONE MOTOR IS CONNECTED, CONNECT TO "M1".
N.B.: IT IS OBLIGATORY TO EARTH THE CENTRAL UNIT (CEI REGULATIONS 61-1).
TECHNICAL SPECIFICATIONS:
- Temperature range
- Humidity
- Supply voltage
- Frequency
- Maximum consumption of card (excluding motors, lamps and external actuators)
- Transient mains power drops
- Maximum power at motor output shaft
- Max. load at flasher output
- Available current at photocell power output
- Radio receiver connector with power supply
- Electrical protection
- Weight of equipment
- Dimensions
- Volume
- All inputs must be used as clean contacts because the power supply is generated on the card and is arranged so as to ensure double or reinforced insulation with
respect to live parts.
- All inputs (function - safety) are controlled by a programmable integrated circuit (PAL).
from 0 to 70°C
< 95% without condensation
230V~ ± 10%
50/60 Hz
70 mA
20 mS
1 Hp
40W 250V cos = 1
0.8A 24Vac ±15%
0.8A 24Vac ±15%
IP 54
3 Kg
20.5x24x10.5 cm
5166 cm
3
Publicité
