Warning And Safety Information - SI Analytics TitroLine 7500 KF Mode D'emploi

1.3 Warning and safety information

®
The TitroLine 7500 KF corresponds to protection class II. It was manufactured and tested according to DIN
EN 61 010, Part 1, Protective Measures for Electronic Measurement Devices and has left the factory in an
impeccable condition as concerns safety technology. In order to maintain this condition and to ensure safe
operation, the user should observe the notes and warning information contained in the present operating
instructions. Development and production is done within a system which meets the requirements laid down in
the DIN EN ISO 9001 standard.
For reasons of safety, the titrator TitroLine
for instance, that work on electrical equipment must only be performed by qualified specialists.
In the case of nonobservance of these provisions the titrator TitroLine
!
danger: electrical accidents of persons or fire hazard. Moreover, in the case of unauthorised
intervention in the titrator TitroLine
caused damage, the warranty will become void.
Prior to switching the device on it has to be ensured that the operating voltage of the titrator TitroLine® 7500
KF matches the mains voltage. The operating voltage is indicated on the specification plate. Nonobservance of
this provision may result in damage to the titrator TitroLine® 7500 KF or in personal injury or damage to
property.
If it has to be assumed that safe operation is impossible, the titrator TitroLine
operation and secured against inadvertent putting to operation. In this case please switch the titrator TitroLine
7500 KF off, pull plug of the mains cable out of the mains socket, and remove the titrator TitroLine
from the place of work.
Examples for the assumption that a safe operation is no longer possible,
 the package is damaged,
®
 the titrator TitroLine
®
 titrator TitroLine
7500 KF does not function properly,
 liquid has penetrated into the casing.
®
The titrator TitroLine 7500 KF must not be stored or operated in humid rooms.
For reasons of safety, the titrator TitroLine
in the present operating instructions.
In the case of deviations from the intended proper use of the device, it is up to the user to evaluate the
occurring risks.
The relevant regulations regarding the handling of the substances used have to be observed: The
!
Decree on Hazardous Matters, the Chemicals Act, and the rules and information of the chemicals trade. It
has to be ensured on the side of the user that the persons entrusted with the use of the titrator TitroLine
7500 KF are experts in the handling of substances used in the environment and in titrator TitroLine
or that they are supervised by specialised persons, respectively.
During all work with titration solutions: ! Please wear protective glasses! !
®
The titrator TitroLine
radiation may penetrate through the device's casing and delete the program.
For working with liquids, not beeing common titration solvents, especially the chemical resistance of the
construction materials of the titrator TitroLine
1.1).
For the use of liquids with high vapour pressure or (mixture of) substances not being mentioned in chapter 1.1
as allowed substances, the safe and proper operation of the titrator TitroLine
by the user.
When the piston moves upwards within the cylinder, a microfilm of dosing liquid or titration solution will always
remain adhered to the inner wall of the cylinder, but this has no influence on the dosing accuracy. This small
residue of liquid, however, may evaporate and thus penetrate into the zone underneath the piston, and if non-
admitted liquids are being used, the materials of the titrator TitroLine
(please refer also to chapter 8 "Maintenance and Care of the titrator TitroLine
Chapter 1 – Specifications Titrator TitroLine
®
7500 KF must be opened by authorised persons only; this means,
®
7500 KF as well as in the case of negligently or deliberately
7500 KF shows visible damages,
®
7500 KF must only be used for the range of application described
7500 KF is equipped with integrated circuits (EPROMs). X rays or other high energy
!
®
7500 KF have to be considered (please also refer to chapter
®
7500 KF
®
7500 KFmay constitute a
®
7500 KF has to be put out of
®
7500 KF has to be guaranteed
®
7500 KF may be dissolved or corroded
®
7500 KF").
79
®
®
7500 KF
®
®
7500 KF