Publicité
Les langues disponibles
Les langues disponibles
Water or cookware on the glass
ER03
over the control area.
Connection between the display
board and the left mainboard fails
F1E
(the cooking zone which indicator
shows "E").
Coil temperature sensor failure.
F3E
(in the cooking zone which
indicator shows "E").
Mainboard temperature sensor
F4E
failure. (in the cooking zone which
indicator shows "E").
Temperature measured by the
E1E
sensor of the ceramic glass is too
high.
Temperature sensor of the IGBT is
E2 E
too high.
Abnormal supply voltage (too
E3 E
high).
Abnormal supply voltage (too
E4 E
low).
Temperature sensor failure (in
E5 E
the cooking zone which indicator
shows E").
Please do not disassemble the unit by yourself to avoid any dangers and damages to
the induction hob.
Choosing the right cookware (F5)
-
Preferably use cookware indicated as being suitable for induction cooking.
-
A magnet-attracting cookware may be suitable for induction cooking.
-
Stainless steel cookware with multi-layer or ferritic stainless-steel bases if the
base indicates: for induction cooking.
-
If cast iron cookware is used, it should preferably have an enamel bottom to avoid
scratching the ceramic hob surface.
-
The following types of cookware are not suitable: glass, ceramic, earthenware,
Clean the control area.
1.Connection cable not correctly
plugged or defective.
2.Replace the mainboard.
Replace the coil sensor.
Replace the mainboard.
Please restart after the hob has
been cooled down.
Please restart after the hob has
been cooled down.
Please inspect whether power
supply is normal. Switch on after
the power supply is normal.
Please inspect whether power
supply is normal. Switch on after
the power supply is normal.
Connection cable not correctly
plugged or the assembly is
defective.
Publicité
