Publicité
Les langues disponibles
Les langues disponibles
• 10R2=M12x1.5 / 10R3=M12x1.5 – with metric inner thread
• 10R2=1/2"-20 / 10R3=1/2"-20 – with inch inner thread
• 10R4=M12x1.5 – with threaded stud M12x1.5 on both sides
• 10R4=1/2"-20 – with threaded stud M12x1.5 on one side; with threaded
stud ½"-20 on the other side
The 10R1 Adapter is used for attaching an Ottobock prosthesis hand to
the Ottobock modular arm prosthesis.
The 10R2=* Adapter is used for attaching an Ottobock system hand or an
Ottobock hook to the Ottobock modular arm prosthesis.
The 10R3=* Adapter is used for attaching an Ottobock system hand or an
Ottobock hook to the Ottobock modular arm prosthesis.
This adapter allows for rotation and flexion of the terminal device. The res-
traint of the rotation is adjustable by screwing the screw A (Fig. 1, item A).
The restraint of the flexion is adjustable by tightening the screw B (Fig. 2,
item B).
The flexion and extension angle amounts to 30°. The rotation and flexion
movements are not locked.
The 10R4 Knurled Plate is used for attaching the passive prosthesis hand
to the 10R2 or10R3 Adapters.
3 Technical Data
Article number
Weight (g)
Total height (mm)
4 Handling
4.1 Assembly
Connect distal tube end to the Modular Adapter (10R2=* / 10R3=*).
INFORMATION
The correct torque of the cap screw is 3.5 Nm (Fig. 3). Use 710D6 Tor-
que Wrench to tighten the cap screw.
10
10R1=*
10R2=*
25
20
43
30
10R3=*
10R4=*
35
15
44
38
Publicité
