Maintenance - Dexter 12VSD2-21.5A Mentions Légales & Consignes De Sécurité

Left/ right switch
shown on the left/right switch
Set the Left/right switch to
Set the Left/right switch to
•Change the direction of rotation only when the machine is not in operation !
CAUTION ! Set left/right switch Lock position during set up, when changing torque setting or when tool is idle.
CAUTION ! Operating the machine with a low speed for a long time will increase the risk that the motor will be overheated. To prevent overheating, let
the motor cool down regularly (stop using the machine for 15 minutes)
CAUTION ! Please support and clamp the workpiece properly. Do not use hand to grip or clamp the workpiece, it may cause injury.
Speed
• Adjust speed by selecting the speed selector to set desired speed.
•
When the number is "1" on the speed button, that means low speed, when the number is "2" on speed button, that means
high speed.
LED worklight
• The LED light will switch on automatically while the trigger switch is depressed.
Torque setting
• The torque setting will help you regulate the driving power using a scewdriver bit. This will help to prevent damage to the workpiece.
For drilling, set the torque selector to position indicated by the drill bit symbol.
Advice: Always start with the lowest torque setting and increase if necessary.

10. MAINTENANCE

Application area
The cordless drill is designed for using and charging in temperature regions with a characteristic temperature of 0°C to 45°C, relative humidity not more
than 80%, the absence of direct exposure to atmospheric pre capitation and excessive dust content of the air.
Requirement for room conditions
to the ignition of dust, steam.
Storage conditions
and relative humidity or not more than 80%.
10
-20°C to 40°C
FR
ES
PT
IT
EL
PL
UA
RO
EN