Drill Safety Warnings - Dexter 12VSD2-21.5A Mentions Légales & Consignes De Sécurité

3. DRILL SAFETY WARNINGS

1) Safety instructions for all operations
a) Brace the tool properly before use. This tool produces a high output torque and without properly bracing the tool during operation, loss of
control may occur resulting in personal injury.
b) Hold the power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may
contact hidden wiring. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator
an electric shock.
2) Safety instructions when using long drill bits
a) Never operate at higher speed than the maximum speed rating of the drill bit. At higher speeds, the bit is likely to bend if allowed
to rotate freely without contacting the workpiece, resulting in personal injury.
b) Always start drilling at low speed and with the bit tip in contact with the workpiece. At higher speeds, the bit is likely to bend if
allowed to rotate freely without contacting the workpiece, resulting in personal injury.
c) Apply pressure only in direct line with the bit and do not apply excessive pressure. Bits can bend causing breakage or loss of
control, resulting in personal injury.
Warning: Harmful and toxic dusts can be produced when you use the tool on hazardous materials. These dusts can endanger the health of operator
and bystanders. Always wear a dust mask when you work, keep bystanders away from the working area and always use the dust collection system
(not supplied).
4. SCREWDRIVER SAFETY WARNINGS
Hold power tool by insulated gripping surfaces, when performing an operation where the fastener may contact hidden
wiring.
Fasteners contacting a «live» wire may make exposed metal parts of the power tool «live» and could give the operator an electric shock.
. If possible, always use clamps or a vice to hold your work.
. Always switch o before you put the tool down.
. Ensure that the lighting is adequate.
. Do not put pressure on the tool, such that it slows the motor down. Allow the bit to screw without pressure. You will get better results and you will be
taking better care of your tool.
. Keep the area free of tripping hazards.
. Only use accessory bits in good condition.
. Before starting, check that there is
. Do not touch the bit away after operation. It will be very hot.
. Keep your hands away from under the workpiece.
. Never use your hands to remove dust, chips or waste close by the bit.
. Rags,cloths,cord,string and the like should never be left around the work area.
. Support the workpiece properly.
. If you are interrupted when operating the tool, complete the process and switch o before looking up.
. Periodically check that all nuts, bolts and other xings are properly tightened.
. When using the tool, use safety equipment including safety glasses or shield. Hearing protection, and protective clothing including safety gloves.
Wear a dust mask if the operation creates dust.
nt clearance for the bit under the workpiece.
6
FR
ES
PT
IT
EL
PL
UA
RO
EN