Publicité
56
immediately.
• Relevant accident prevention regulations and other,
generally recognized safety-technical rules must also
be adhered to.
• The Scheppach machine may only be used, main-
tained, and operated by persons familiar with it and
instructed in its operation and procedures. Arbitrary
alterations to the machine release the manufacturer
from all responsibility for any resulting damages.
• The Scheppach machine may only be used with original
accessories and original tools made by the manufac-
turer.
• Any other use exceeds authorization. The manufacturer
is not responsible for any damages resulting from un-
authorized use; risk is the sole responsibility of the
operator.
m
Remaining hazards
The machine has been built using modern technology in
accordance with recognized safety rules. Some remaining
hazards, however, may still exist.
• The rotating saw blade can cause injuries to fingers
and hands if the work piece is incorrectly fed.
• Thrown work pieces can lead to injury if the work piece
is not properly secured or fed, such as working without
a limit stop.
• Noise can be a health hazard. The permitted noise
level is exceeded when working. Be sure to wear per-
sonal protective gear such as ear protection.
• Defective saw blades can cause injuries. Regularly in-
spect the structural integrity of saw blades.
• The use of incorrect or damaged mains cables can lead
to injuries caused by electricity.
• The operating instructions supplied with the special
accessories must be observed and carefully read when
Scheppach special accessories are used.
• Even when all safety measures are taken, some re-
maining hazards which are not yet evident may still
be present.
• Remaining hazards can be minimized by following the
instructions in "Safety Precautions", "Proper Use" and
in the entire operating manual.
Setting up
Prepare the location where the machine is due to be
mounted Make sure there is sufficient space to enable a
safe failure free functioning The machine is designed for
operation in enclosed areas and is to be set up on a sta-
ble level surface This stability is provided by two frame
angles and two hexagon screws each attached to the floor
with screw nut and disc.
Publicité
