Publicité
54
m Use only as authorized
The machine corresponds to the valid EC guideline.
• The circular sawbench is defined as a transportable
machine.
• To transport the machine, grasp the table firmly at
the front and at the rear using both hands and lift the
machine.
• If an original base is not used, the machine must be
placed firmly upon a stable stand resembling a table.
The working height should be 850 mm.
• The machine's workstation is in front of the machine
to the left of the saw blade.
• The machining range and surrounding areas of the
machine must be clear of interfering foreign matter to
prevent accidents occurring.
• Workpieces must be completely free of foreign objects,
i.e. nails or screws.
• Before the machine is put into operation it must be
connected to a dust extractor with a flexible, non-
flammable suction hose. The suction should switch on
automatically when the machine is switched on.
• When
used
in
enclosed
must be connected to a vacuum exhaust unit.
Use the Scheppach dust extractor ha 3200 or ha 2600
to remove match wood or saw dust. The vacuum sup-
port flow rate must be 20 m/s. Subatmospheric pres-
sure 1200 Pa.
• The Scheppach automatic switching unit is available
as a special accessory.
Type ALV 2
Art. No. 7910 4010
Hz
The vacuum exhaust unit automatically switched on af-
ter a 2-3 second delay after the machine tool is turned
on. This avoids overloading the circuit fuse.
After turning off the machine tool, the vacuum ex-
haust unit remains on for an additional 2-3 sec-
onds and is then automatically switched off.
Remaining dust is thereby removed by vacuum exhaust,
as required by German regulations governing hazardous
materials. This results in savings in electricity con-
sumption and reduces noise levels, as the vacuum ex-
haust unit is on only during machine tool operation.
• For work in commercial spaces, an appropurate dust
extractor must be used. Do not remove or shut off
vacuum exhaust systems or dust removers while ma-
chine tools are operating.
• The circular sawbench is designed exclusively for the
machining of wood and materials similar to wood. Only
original Scheppach tools and accessories may be used.
Use the required sawblade in accordance with the EN
847-1 norm depending on the type of cut and type
of wood (solid wood, plywood or chipboard). Please
observe the „Special Tool Accessories".
• The machine must only be used in technically perfect
condition in accordance with its designated use and
the instructions set out in the operating manual, and
only by safety-conscious persons who are fully aware
of the risks involved in operating the machine. Any
functional disorders, especially those affecting the
safety of the machine, should therefore be rectified
rooms,
the
machine
230 V / 50
Publicité
