Seq (Sequencer) Group; Midi Control; Count Switch; Sync Mode - Yamaha DTXPRESS III Mode D'emploi

Utility Mode

5. SEQ (Sequencer) Group

This sub-mode contains settings that relate to the sequencer (song).
This group is divided into the following 4 pages.

5-1. MIDI Control .................................................... 36

5-2. Count Switch ................................................... 36

5-3. Sync Mode ...................................................... 36

5-4. Use Tempo ...................................................... 36

5-1. MIDI Control

This enables or disables the DTXPRESS III to transmit or receive
system real-time messages (start/continue/stop).
When this function is enabled, you can control an external se-
quencer or rhythm machine from the DTXPRESS III. Control of
the DTXPRESS III from an external sequencer or rhythm machine
is also possible.
UT SEQ SETUP
MIDI Control=off
q MIDI Control
on: Transmits and receives the following system real-time mes-
sages.
• Transmits timing clock (F8) (transmit only)
• Transmits and receives start, stop, and continue
(FA, FB, FC)
off: Does not transmit or receive system real-time messages.

5-2. Count Switch

This function turns the 2 bar countdown before the song starts
playback, on or off.
UT SEQ SETUP
Count Switch=off
q Count Switch
on: After a 2 bar countdown, the song will start playback.
off: No countdown, the song will start playback immediately.
36
This function synchronizes the DTXPRESS III sequencer's clock
with the clock of an external device.
q Sync Mode
int: Movement is determined by the DTXPRESS III's internal
ext: Movement is determined by the clock of an external device
auto: If a timing clock (F8) is received via the MIDI IN/TO HOST
q
This function sets the tempo of a song to either change each time
to its default tempo, or remain unchanged at the currently set tempo
when the song is switched.
q Use Tempo
song:
global: The tempo remains unchanged at the currently set tempo
q

5-3. Sync Mode

UT SEQ SETUP
Sync Mode= auto
clock.
received via the MIDI IN/TO HOST jacks.
jack the external clock will be used If a timing clock (F8) is
not received the internal clock will be used.

5-4. Use Tempo

UT SEQ SETUP
Use Tempo= song
Changes the tempo of the song to its default tempo when
the song is switched.
when the song is switched.
q
q