Parts Description; Technical Data; Safety; Safety Notices - LIVARNO LUX 54739 Instructions De Montage, D'utilisation Et Consignes De Sécurité

Parts Description

Wall plug
1
Ceiling mount
2
Screw
3
Seal
4
IP65 screw
5
LED moisture-proof lamp
6

Technical Data

Item number: 54739
Operating voltage: 220–240 V∼ 50 / 60 Hz
Illuminant: LED module (not replaceable)
Rated power max.: 25W
Protection type: IP65 (dust/splash-proof)
Protection class: II /
Dimensions: 1250 x 65 x 65 mm
Distributor:
EDI Light GmbH, Heiligkreuz 22, A-6136 Pill

Safety

Safety Notices

Damage due to failure to comply with these operat-
ing instructions will invalidate the warranty! We
assume no liability for consequential damage! We
assume no liability for property damage or per-
sonal injury due to improper handling or failure to
observe the safety notices!
ACCIDENT AND DANGER TO
LIFE FOR INFANTS AND
CHILDREN!
This device may be used by children aged 8
years and up, as well as by persons with re-
duced physical, sensory or mental capacities,
or those lacking experience and/or knowl-
edge, as long as they are supervised or in-
structed in the safe use of the device and they
understand the associated risks. Do not
RISK OF
Introduction / Safety
allow children to play with the device. Clean-
ing and user maintenance must not be per-
formed by children without supervision.
Do not leave the light or packaging material
lying unattended. Plastic film or bags, plastic
parts, etc. can turn into dangerous toys for
children.
Avoid the risk of fatal injury
from electric shock
Have the electrical installation carried out by a
trained electrician.
We assume no liability for property damage or
personal injury due to improper handling or
failure to observe the safety notices!
Never use the light if any defects have been
identified.
Always check the light for any damage before
connecting it to the mains. Never use the light if
it shows any signs of damage.
Prior to installation, remove the fuse or switch
off the circuit breaker (0 setting) in the fuse box
(see Fig. A).
Before assembly, ensure that the mains voltage
available corresponds to the operating voltage
required by the light (220–240 V ∼).
Never touch the high-voltage circuit board if
the plastic cover or lamp housing are damaged.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Do not install the light on a wet or conductive
surface!
Preventing fire and
injury hazards
Check each lamp and each plastic cover for
damage immediately after unpacking.
Immediately replace a broken plas-
tic cover with a new one.
Contact the service centre or an electrician.
The LED light is not dimmable.
GB/IE/NI 7