Warn Industries POWERPLANT Guide D'installation Et Operateur page 5

WARNING
RISK OF EXPLOSIONS OR FIRE
Failure to observe these instructions could lead to
serious injury or death.
• Always operate the compressor in a well ventilated
area free of combustible materials, gasoline, or
vapors.
• Always store fl ammable material in a secure location
away from compressor.
• Never restrict or block any of the compressor
ventilation openings.
• Never operate unit indoors or in any confi ned area.
• Never allow the compressor to operate unattended.
• Never place objects against or on top of compressor.
WARNING
RISK OF BURNS
Failure to observe these instructions could lead to
serious injury or death.
• Never touch any exposed metal parts on compressor
during or immediately after operation.
• Never reach around protective shrouds or attempt
maintenance until unit has been allowed to cool.
WARNING
RISK TO BREATHING
Failure to observe these instructions could lead to
serious injury or death.
• Never use air from compressor to supply air for
human consumption.
GENERAL SAFETY PRECAUTIONS
WARNING
RISK OF BURSTING
Failure to observe these instructions could lead to
serious injury or death.
• Always drain intercooler daily or after each use. If
intercooler develops a leak, replace it immediately
with a new intercooler or replace the entire
compressor.
• Never drill into, weld, or make any modifi cations to
the intercooler or its attachments.
• Never make adjustments or parts substitutions to
alter the factory set operating pressures.
• Never exceed the pressure rating of air tools, air
operated accessories, tires, and other infl atables.
• Always install a pressure regulator and pressure
gauge to the air outlet (if not equipped) of your
compressor if air control is necessary.
• Always follow the equipment manufacturers'
recommendations.
• Never exceed the maximum allowable pressure
rating of attachments.
• Never use compressor to infl ate small low-pressure
objects such as children's toys, footballs, basketballs,
etc.
WARNING
RISK FROM FLYING OBJECTS
Failure to observe these instructions could lead to
serious injury or death.
• Always wear ANSI Z87.1 approved safety glasses
with side shields when using the air compressor.
• Never point any nozzle or sprayer toward any part of
the body or at other people or animals.
• Always turn the compressor off and bleed pressure
from the air hose and intercooler before attempting
maintenance, attaching tools, or accessories.
WARN INDUSTRIES
5
GENERAL SAFETY PRECAUTIONS
WARNING
CHEMICAL AND FIRE HAZARD
Failure to observe these instructions could lead to
serious injury or death.
• Always remove jewelry and wear eye protection.
• Never route electrical cables across sharp edges.
• Never route electrical cables near parts that get hot.
• Never route electrical cables through or near moving
parts.
• Always place the supplied terminal boots on
wires and terminals as directed by the installation
instructions.
• Never lean over battery while making connections.
• Never route electrical cables over battery terminals.
• Never short battery terminals with metal objects.
• Always verify area is clear of fuel lines, fuel tank,
brake lines, electrical wires, etc., when drilling.
• Always consult operator's manual for proper wiring
details.
• Always insulate and protect all exposed wiring and
electrical terminals.
CAUTION
CUT AND BURN HAZARD
Failure to observe these instructions could lead to
minor or moderate injury.
• Never let winch rope slip through your hands.
73203B0 73203B0
CAUTION
MOVING PARTS ENTANGLEMENT HAZARD
Failure to observe these instructions could lead to
minor or moderate injury.
To avoid injury to hands or fi ngers:
• Never leave remote control where it can be activated
during free spooling, rigging, or when the winch is not
being used.
• Never leave the winch remote control plugged in
when installing, freespooling, rigging, servicing or
when the winch is not being used.
N OTI CE
AVOID WINCH AND EQUIPMENT DAMAGE
• Always avoid side pulls which can pile up winch rope
at one end of the drum. This can damage winch rope
or winch.
• Always ensure the clutch is fully engaged or
disengaged.
• Always use care to not damage the vehicle frame
when anchoring to a vehicle during a winching
operation.
• Never submerge winch in water.
• Always store the remote control in a protected, clean,
dry area.
WARN INDUSTRIES
6