Routing-Functions; External Sound Sources; Computer Konfiguration - Reloop beatpad MIDI Mode D'emploi

ToP suRface
24 Linefader
Via the linefader you can adjust the channel's volume.
25 Master Volume
Via this dial master volume can be adjusted. This dial is analog and does not send any
MIDI signal.
26 Headphones Volume
Via this dial you can adjust headphones volume. This dial is analog and does not send any
MIDI signals.
27 CUE Mix Fading
The cue mix dial can be used to simulate a pre-mix via your headphones. When to the
right the master signal is audible, when to the left the CUE signal becomes audible.
28 Aux Volume Via this dial you can adjust aux volume (rear side). This dial does not send
any MIDI signals.
29 Record Button
Starts a recording when pressed (LED is lit). Pressing again stops the recording (LED
goes out).
30 Track Navigation
By pressing you call up playlist view. If you press again, the selected track will be loaded
onto the inactive deck.
31 Connectivity LED
If the iPad/USB LED is lit, the iPad/PC is connected correctly. If the DATA LED is lit,
commands are successfully being sent from the controller.
32 Crossfader
Via the crossfader you can fade between the decks.
33 VU-Meter
The VU meter shows the output level (PFL) of the respective decck.
4. RouTIng funcTIons
Your Reloop Beatpad disposes of various routing possibilities in order to integrate already existing equipment.
4.1 Microphone
At the device's front side you can connect a microphone with 6.3 mm jack connection. Headphones volume can be adjusted with the adjacent dial.

4.2 external sound sources

At the device's rear side you can connect an external sound source via RCA to the Beatpad and integrate it in the controller setup. The input
signal's volume can be adjusted via the aux dial. Moreover, you have the possibility to connect a turntable to Beatpad. To do so, bring the input
switch in the "PH" position. If you want to connect a line source, such as CD player or mibile phone, put the switch in the "LN" position.

5. coMPuTeR konfIguRaTIon

In order for the device to run flawlessly under Windows the installation of a driver is necessary. Under Mac OSX this installation is not necessary.
Furthermore make sure that all other programs have been closed before use. Please pay special attention to the following items.
Insert the included installation CD in your drive. In the folder "Drivers" select the included ASIO driver and start the installation with a double click.
TIP! Reloop regularly provides updated drivers online. Please regularly check under www.reloop.com for updates.
noTe! Please make sure that you start the driver installation with admin rights. otherwise the installation may fail with an error message.
15