For your safety
1.
For your safety
The luminaire has been designed in accord-
ance with state-of-the-art standards, manu-
factured with utmost care using high-quality
materials, and tested.
Nevertheless, its use may constitute a risk
to persons or cause material damage.
X Read all enclosed instructions and infor-
mation.
X Please observe the warnings included
in the documentation and attached to
the unit.
X The device must only be used in tech-
nically perfect condition, and only by
persons being aware of the risks and
dangers involved in operating the
device.
X Keep this document available near the
device.
1.1
Designated use
This luminaire is a high bay luminaire for
illuminating factory halls.
1.2
Safety instructions
Explosion hazard
Operating the luminaire in rooms subject
to explosion hazards can trigger an explo-
sion and result in serious injuries or death.
X Do not operate the luminaire in rooms
subject to explosion hazards.
Danger due to electric current
Improper use and faulty work on the lu-
minaire may result in injuries and mate-
rial damage.
X Connection by a skilled electrician only.
X Compare the mains voltage with the
nominal voltage and the frequency
specified on the rating plate and make
sure that they are identical.
X Luminaire with plug-in connector: Dis-
connect a damaged connecting cable
immediately from the power supply
and replace it with a suitable cable, see
chapter 4.2 "Connecting the luminaire
with plug-in connector" , page 23.
X Luminaire without plug-in connector:
Disconnect a damaged connecting
cable immediately from the power sup-
ply and have it replaced by the manu-
facturer or his service representative.
X Have maintenance and repair work car-
ried out by a trained electrician only.
X Before performing work on the lumi-
naire, disconnect the luminaire from
the power supply.
Safe mounting
A falling luminaire can result in death or
serious injuries.
X Have the mounting performed by a
qualified professional only.
X Mount the luminaire on a suitable wall
or ceiling using suitable fastening ele-
ments only.
X Mount fastening elements correctly.
ENG
17