Automatic ice maker (freezer only)
Before turning on your automatic ice maker, the water filter must be installed
(refer to your Installation Guide) and flushed to remove any impurities or trapped air
in the filter system.
Press the
,
●
●
tray will flip twice and empty the water into the bin below. The ice tray will flip only
after the doors are closed.
Repeat the cycle to remove dust in the ice tray collected during manufacture and transport.
●
●
Empty the water bin and return it correctly.
●
●
Once your ice maker is turned on, you must discard the first full bin of ice made.
●
●
For optimum water filter performance we recommend you discard the next two to
three full bins of ice before consumption.
Turn the ice maker off if:
There is no water supply for several hours.
●
●
You are removing the ice storage bin for a period of time.
●
●
You are going on holiday/vacation.
●
●
Water filter
The water supplied to your appliance for ice making is filtered to remove impurities
through a filter located the bottom front of your appliance. Replace your filter
cartridge every 6 months.
There is a replacement indicator icon
●
●
the filter needs replacing.
Replacement filter cartridges are available from your Fisher & Paykel dealer or online.
●
●
The details of the replacement filter cartridge are labelled on the cartridge.
To reset the filter indicator:
Press the
and
●
●
The
on the control panel will turn off when reset.
●
●
Alarm mute
If the doors are left open for 5 minutes or more, the compartment light turns off
●
●
and normal door alarms are suspended.
To activate, press the
●
●
The light above the
●
●
'Alarm Mute' will deactivate after 20 minutes.
●
●
To deactivate manually, press the
●
●
Closing the door also deactivates the 'Alarm Mute'
●
●
OPERATING INSTRUCTIONS
and
buttons together for 4 seconds then close the doors. The ice
buttons for 4 seconds.
button once.
button will illuminate to indicate the appliance is muted.
on the control panel which will appear when
button again.
EN
15