sparraw SP-RUN103 Manuel D'utilisation page 49

E11
E14
6.1. Constitution test:
At the standby state, press the "PROGRAM" key repeatedly to enter into FAT
test state, then press mode "key" to enter F-1, F-2, F-3, F-4, F-5 interface
(F-1—sex, F- 2—age, F- 3—height, F-5-FAT test), press "speed+" and
"speed-" keys to set the parameters from 01—04 (see the following table); then
press "MODE" key to enter F-5 FAT interface, at this time hold heart rate plate
for 4-5 seconds, then it will show your FAT, check your weight and height and
see whether they match with each other. The FAT is a figure that measures the
ratio between height and weight, it does not show the body proportion. FAT
suits all men and women, and it is a base for people to adjust their height and
weight as other healthy indexes. The ideal FAT should be between 20—25, if
the figure is below 19, it means you are too thin, and if above 25 and 29, that
means overweight, and if above 30, that means you are getting fat. (these data
are only for references, and are not medical data.)
01
02
03
04
05
B) motor short circuit
C) driving position hinder
Input voltage too big
Input voltage too low
Sex
Age
Height
Weight
FAT
FAT
FAT
FAT
01 M
10------99
100----240
20-----160
≤19
=(20---25)
=(25---29)
≥30
- 49 -
position
Change new motor
Adjust driving position,
or add oil
Stop using, ask electrician
to check
Stop using, ask electrician
to check
02 F
Underweight
Normal weight
Overweight
Obesity