sparraw SP-RUN103 Manuel D'utilisation page 47

7. TROUBLE SHOOTING
ERRO CODE
NO DISPLAY
NOT DISPLAY
ALL
INFORMATION
NOT RUN
SMOOTHLY
---OR----
(OR
E00/E07)
E01/E13
REASON
A) electricity not connected
B) power switch not turn on
C) pcb no power or broken
D) signal wire not connected
E) computer broken
F) background light broken
A) display drive IC not inserted
well
B) EMI gasket slip, not well
fastened
A) driving position has resistance
B) running belt too tight or too
loose
C) pcb torque too big or too small
A) safety key off
B) magnetron not fixed well
A) signal wire not well connected
B) signal wire broken
C) signal wire broken
D) pcb broken
- 47 -
HOW TO SOLVE
Connect the electricity
Turn on power switch
Press over-load protector
or change new pcb
Re-connect signal wire or
change new one
Change new computer
Check background light
wire or change new one
Re-insert IC,and re-weld
it or change new one
Re-assemble screen
Adjust driving position,
or add some silicon oil
Adjust the belt tension
Ajust torque to right
position
Put on safety key
Fix magnetron to right
position
Re-connect signal wire
Change new signal wire
Change new computer
Change new pcb