Fisher & Paykel DCS RF195A Guide D'utilisation page 27

Using your ice maker
EN
25
Information about your ice maker
Your automatic ice maker will produce approximately eight cubes of ice every 2 – 3 hours,
depending on freezer compartment temperature and number of door openings.
The ice cube tray will fill with water once the freezer has reached the correct temperature.
The first cubes will normally be produced after several hours.
When cubes are frozen, they will be ejected from the ice tray into the ice storage bin.
Ice making will continue until the storage bin is full.
Ice making will resume when the ice is used.
For maximum ice storage, level the stored cubes with the ice scoop provided.
Your Ice & Water product comes with a smaller ice bin inside the larger freezer bin. Attached to
this is the scoop for the ice. This scoop provides hygienic access to the ice.
If a large amount of ice is required, remove the smaller storage bin and allow ice to fall into the
larger bin.
If ice is not used often, old cubes will become cloudy, taste stale, will shrink and may stick
together. Empty the ice storage bin periodically, wash in lukewarm water, dry thoroughly and
place back in the correct position.
Fig.18 Ice storage bin and scoop in correct position
Important!
Avoid contact with the moving parts of the ice maker ejector mechanism, and do not place your
fingers on the automatic ice making mechanism while the refrigerator is in operation.
Do not use ice cubes that may have become discolored, usually with a green-blue color. If such
discolouration is noted, discard the ice cubes and contact your DCS Authorized Service Agency or
DCS Customer Care Representative.
Ensure the ice maker is connected to the filter and only to a drinkable water supply.
Installation of the water connection to the ice maker must be completed by a qualified service
technician or a qualified plumber (see installation instructions).