Fisher & Paykel DCS RF195A Guide D'utilisation page 14

Installation instructions
EN
12
Wind both front feet up and roll the product out
9
of position.
Place the packing material in the location
a
diagonally opposite the front roller that
lifts off the floor.
Make sure the packaging material stays in
b
place when the product is pushed back
into position.
Ideally, the packing material is large enough to
c
rest against the back wall so as to prevent
it moving when the cabinet is pushed into
position.
Roll the refrigerator back into position and adjust
10
front rollers as per step 5 (check alignment and
door closing action are satisfactory).
Make small adjustments to front rollers where
a
necessary.
Firmly screw front feet down on the ground.
b
Check that the product is stable (all 4 feet are
c
on the floor). If not, return to step 7 and repeat
8, 9 and 10.
Place toe grille on the bottom of the
d
refrigerator (refer to step 5d).
Packing material goes under rear roller
diagonally opposite front foot that lifts
Wall behind
refrigerator
This foot lifts off the floor when pushing
gently on the top front of the refrigerator
Fig.7 Stabilizing your refrigerator