6. Leveling the refrigerator door
If doors are uneven, do the following:
6
Determine which door needs to be raised.
a
Turn the front roller adjustment screw (
b
on that side clockwise to raise front corner of door.
If one adjustment screw has reached the limit of its
c
adjustment range and the doors are still not level,
lower the opposite door by turning the roller
adjustment screw counterclockwise.
Check with level to verify 3⁄8" (10 mm) tilt to the back
d
for proper door closure.
Once refrigerator is aligned, screw feet firmly in place
e
and attach toe grille (refer to step 5d).
7. What to do if the product is unstable
Gently pull the refrigerator forward and screw down the
7
feet until they make contact with the floor.
Push the refrigerator back until the rear rollers contact
8
the floor.
Measure the gap under the front foot, which has come
a
off the floor.
Obtain some solid packing material (hardwood,
b
plastic, etc), which fits firmly into the gap under
the foot.
Note: do not use metallic materials that may corrode,
stain and/or damage floor coverings.
Installation instructions
Fig.3 )
a,
Fig.5 Uneven door alignment
This foot lifts off the floor when
top front is gently pushed back
Fig.6 Unstable refrigerator
EN
11
Example only
Un-level floor