Publicité
Les langues disponibles
Les langues disponibles
Gossmann GmbH
The heating element becomes very hot during use. Contact could lead to serious burns.
All of our infrared heaters are equipped with temperature sensors, which protect the surface of the appliance against possible
overheating.
If the infrared heater is not to be used for a longer period of time, it is advisable to disconnect the mains plug.
The surface of the infrared heater should be kept clean at all times. Observe the detailed information given below.
3.7 INSTRUCTIONS FOR CLEANING AND MAINTENANCE
Infrared heaters require no maintenance. If you should find anything abnormal, please disconnect the mains plug and immedi-
ately contact the dealer from whom you purchased the infrared heater.
For cleaning it is best to proceed as follows:
Be sure to disconnect the mains plug before cleaning.
The heating element is very hot after use (up to 120 °C depending on the model, risk of burns). Let the heating element cool
down first (about 10 to 15 minutes) before cleaning it.
Never clean the heating element by immersing it in water or spraying it with water. Never use a wet cloth. Clean it only with a
duster or a slightly moistened cloth. Make sure that the heating element is completely dry before putting it into operation again.
Do not use scouring agents, other aggressive substances or rough cloths. Infrared heaters should be wiped only with a dry
cloth.
3.8 INSTRUCTIONS FOR REPAIR
If anything about your appliance is abnormal, always contact your dealer – never attempt to repair the appliance yourself.
If case of a malfunction of the device, disconnect the mains plug immediately. Do not use the appliance or stop using it imme-
diately if the appliance is damaged, in particular if the mains cable, housing or heating element itself is affected.
Furthermore, we kindly request that you read the detailed warranty information given below.
Never remove the type plate and the warning label. The data given on the type plate are of importance for the warranty.
4.
TECHNICAL DETAILS
The following information general applies to all heating systems. Please observe the information regarding performance, size
and surface temperature on the label on the rear side of your infrared heater in connection with the technical data sheets.
Voltage
Power
230 V
250 - 850 W
5.
FOR THE SAKE OF OUR ENVIRONMENT
Do not simply throw away packaging material. Please observe the following information:
Packaging material made of cardboard can be taken to the waste paper collection point or disposed of via the appropriate
system.
Keep plastic films and packaging out of the reach of children. Please recycle protective films properly.
Frequency
Size
50/60 Hz
30*90 - 60*150 cm
Weight
2 - 60 kg
GB
13
Publicité
