Canon JX510P Guide D'utilisation page 85

Back of the Paper Is Smudged
Cause
The paper and print quality settings are
not set properly.
Inside of the machine is dirty.
Machine Does Not Start or Stops During Print Jobs
Printing Does Not Start
Cause
Unnecessary print jobs are left in
queue. / Computer problems.
The machine is not ready.
The machine is not connected properly. Make sure that the USB cable is securely plugged in to the machine and the
Your machine is not selected in the
printer driver.
The printer port is not configured
appropriately.
82 Troubleshooting
Confirm the paper and print quality settings.
See "Print Results Not Satisfactory" on page 80.
Perform the Bottom Plate Cleaning to clean the inside of the machine.
For details on cleaning, see "Cleaning Your Machine" on page 68.
Note
To prevent the inside of the machine from getting stained, set the page size
correctly.
Restart your computer if you are printing from the computer.
If there are any unnecessary print jobs, delete them.
Refer to the On-screen Manual.
Make sure that the power plug is securely plugged in, then turn the machine on.
While [ON] is flashing green, the machine is initializing. Wait until [ON] stops
flashing and remains lit green.
Note
When printing large data such as a photo or graphics, it may take longer to start
printing. While [ON] is flashing green, the computer is processing data and
sending it to the machine. Wait until printing starts.
computer.
If you are using a relay device such as a USB hub, disconnect it, connect the
machine directly to the computer, and try printing again. If printing starts
normally, there is a problem with the relay device. Consult the reseller of the
relay device for details.
There could also be a problem with the USB cable. Replace the USB cable
and try printing again.
The machine will not print properly if you are using a driver for a different printer.
Make sure that your machine's name is selected in the Print dialog box.
Note
To make your machine the one selected by default, select Set as Default
Printer.
Check the printer port settings.
* In the following instruction, "XXX" signifies your machine's name.
(1)Log into a user account with the administrator privilege.
(2)Click Control Panel, then Printer under Hardware and Sound.
In Windows XP: Click Control Panel, Printers and Other Hardware, then
Printers and Faxes.
In Windows 2000: Click Control Panel then Printers.
(3)Right-click the Canon XXX icon, then select Properties.
(4)Click the Ports tab to confirm the port settings.
Make sure that a port named USBnnn (where "n" is a number) with Canon
XXX appearing in the Printer column is selected for Print to the following
port(s).
If the setting is incorrect, reinstall the printer driver or change the printer port
to the correct one.
Action
Action