Canon JX510P Guide D'utilisation page 39

Telecom FaxAbility (New Zealand only)
Telecom N.Z. offers the FaxAbility capability. If you subscribe to this service, your line is assigned
two numbers: one for fax and one for phone. When the fax number is called, the network sends a
specific ringing tone which your fax recognizes and automatically handles as a fax call. If the phone
number is called, a different ringing tone is sent out from the network so that the call is handled as a
voice call. This means that there is no switching delay at the other party's end.
Contact Telecom for connection information.
Setting the Fax for Network Switch
1
Press [Receive Mode/Resolution] to select <NET SWITCH>.
See "Setting the Receive Mode" on page 33.
}
The fax returns to standby mode.
Operation for Network Switch System
The procedures for using the network switch system are almost the same as when using the fax
over a normal telephone line. When you receive calls, however, the fax will respond slightly
differently as described below.
When you hear the telephone call ring pattern:
Pick up the Handset and talk normally. If you hear a slow beep, it means the call is from a fax
machine trying to send a document. Press [Start/Copy] to receive the document. If you do not
pick up the Handset, the fax continues to ring until the other party hangs up. If an answering
machine is connected, it takes over the call.
When you hear the fax call ring pattern (double ring):
After the fax rings, it receives the document automatically.
Other Features
Saving Ink
You can enable/disable ink-saving feature by selecting <INK SAVER> when [Menu] is pressed.
Note
By enabling this feature, print quality will be reduced. For highest print quality, disable this feature.
1
Press [Menu].
2
Use [{] or [}] to select <DATA REGSTRATION>, then press [Start/Copy].
3
Use [{] or [}] to select <PRINTER SETTINGS>, then press [Start/Copy].
4
Use [{] or [}] to select <INK SAVER>, then press [Start/Copy].
5
Use [{] or [}] to select <ON> or <OFF>, then press [Start/Copy].
6
Press [Stop/Reset].
Setting ends and the fax returns to standby mode.
36 Receiving Faxes