Using Tam Mode (Jx510P Only) - Canon JX510P Guide D'utilisation

Using TAM Mode (JX510P only)

Recording the Outgoing Message
Before you use the built-in answering machine (TAM), you must record an outgoing message. Use
the Handset on the fax to record your outgoing message. Only one outgoing message, no longer
than 20 seconds, can be recorded.
Note
You cannot receive documents while you are recording a message or voice memo. Also, the <CALLER
ID> feature (see page 38) may not work properly.
Types of Messages that can be Recorded
<OUTGOING MESSAGE>: Answering machine message, used when <PLAY MESSAGE> has
<ALT OUTGOING MSG>: Answering message only, used when the recording time is set to 0,
<VOICE MEMO>:
<FAXTEL MESSAGE>:
<FORWARDING MSG>:
Recording the Outgoing Message
To record another type of message, select the type of message you want to record in step 3, and
then follow the procedure below to record it.
1
Press [Menu].
2
Use [{] or [}] to select <MSG REGISTRATION>, then press [Start/Copy].
3
Use [{] or [}] to select <OUTGOING MESSAGE>, then press [Start/Copy].
You can record an alternative outgoing message, fax/tel message or forwarding message by
selecting the appropriate message and then continuing on to steps 4 to 7.
4
Use [{] or [}] to select <RECORD>, then press [Start/Copy]. The LCD displays
<LIFT HANDSET>.
5
Pick up the Handset. Press [Start/Copy] and speak into the Handset to record your
outgoing message.
The remaining recording seconds is displayed on the LCD.
6
Press [Stop/Reset] when recording is finished. The LCD displays <REPLACE
HANDSET>.
42 Using TAM Mode (JX510P only)
been selected when the call is disconnected (see page 39). Caller
cannot leave a message.
or the memory is full.
See page 45.
Message played when <Fax/Tel Mode> is set. The fax receives
documents automatically and only rings for voice calls.
Message played when any new telephone messages are forwarded
to a forwarding number.