Canon JX510P Guide D'utilisation page 23

Problem Documents
To prevent document jams in the ADF, do not attempt to load the following types of
documents into the fax:
- Wrinkled or creased paper
- Torn paper
- Coated paper or glossy paper
- Thick paper
Remove all staples, paper clips, etc. before loading the document into the ADF.
Make sure any glue, ink, or correction fluid on the paper is completely dry before loading the
document into the ADF.
Make a photocopy of any document that will not feed into the fax so that you can then load the
copy into the ADF.
Paper Requirements
Your fax supports A4-, letter-, and legal-size paper in portrait orientation. You can use regular copier
paper, cotton bond paper, or typical letterhead. Your fax does not require special ink jet paper.
Always use paper without curls, folds, staples, or damaged edges. Look at the label on the package
to see if the paper has a preferred side for printing.
Note
Be sure to test paper before purchasing large quantities.
Printable Area
The shaded area below shows the printable area of letter- and legal-size paper. Be sure to print
within this area.
DIRECTION
20 Before Using Your Machine
FEED
6.4 ±1.5 mm
- Curled or rolled paper
- Carbon paper or carbon-backed paper
- Onion skin or thin paper
- Envelopes
5 mm
LTR/LGL
3 ±1.5 mm
6.4 mm~