Festool HK 55 EQ Guide D'utilisation page 20

Loosen saw from the cross cutting guide rail.
Push saw forward slightly in sawing direction.

Turn quick fastener [9-1] to the front.

Remove saw towards the rear against the saw-

ing direction.
10
10-3
10-2
Procedure for compound mitre saws
Open knob at adjustable stop [10-1].

Adjust angle at the scale [10-3].

Close knob at adjustable stop [10-1].

Adjust depth and angle of the saw, see chap.

Adjusting the cutting depth and Adjusting the
cutting angle.
Adjust the guide play between the saw table and

20
10-1
the track rail using the two adjustable jaws [10-
2].
The saw must glide easily across the rail.
Place the adjustable stop [10-1] and the fixed

stop against the work piece and position the
track rail.
Switch saw on.

Push saw in direction of cutting.

Pendulum guard opens. Saw section.
WARNING
Protruding rotating saw blade
Risk of injury
Do not position hands near cutting area and saw

blade.
Do not place hands below the work piece.

Do not hold the workpiece in hand or place it on

your leg.
After cutting, switch off saw.

Pull back saw into initial position.

Remove cross cutting guide rail from work

piece.
not lay down! If the saw or the pendulum guard
does not retreat to initial position, interrupt sawing
process and check functionality, possibly remove
jammed woodchips.
laid down with the cross cutting guide rail.
Warning! Danger
of injury!
blade exposed, do
Parking position - pendu-
lum guard closed! In park-
ing position the saw can be
Saw