Edirol UM-2 Mode D'emploi page 27

Using OMS on the Macintosh
Installing the UM-2 Driver
Use the following procedure to install the UM-2 driver.
* Disconnect the UM-2 from your computer before starting up
Macintosh.
* Exit all applications before you begin installing the driver.
* The UM-2 OMS Driver included on the disc is provided as an
additional module that allows the UM-2 to be used with OMS. In
order to use it, OMS must already be installed on the start-up hard
disk.
To learn more about OMS
If you would like to learn more about OMS, please refer
to "OMS_2.3_Mac.pdf" (on-line manual) located in the
"OMS 2.3.8E" folder on the CD-ROM. In order to read
"OMS_2.3_Mac.pdf," you will need the Adobe Acrobat
Reader.
1
In the "UM-2 Driver E" folder of
the CD-ROM, double-click the
"UM2 OMS Driver-E Installer"
icon.
2
Make sure that OMS is
already installed in the
location where the driver
will be installed, and
click [Install].
3
If the following message
appears, click [Continue]
and all other currently-
running applications will
be exited, and
installation will continue.
Installing & Setup the Driver
To install OMS, double-click
the Install OMS 2.3.8 icon
located in the OMS 2.3.8E
folder.
27