Edirol UM-2 Mode D'emploi page 16

Installing & Setup the Driver
Windows 98 / Me Users
Use the following procedure to install the UM-2 driver.
* Disconnect the UM-2 from your computer before starting up
Windows.
1
With all USB cables disconnected, start up Windows.
(except the keyboard and mouse)
2
Exit all applications before you begin installing the
driver.
3
Insert the UM-2 Driver CD-ROM into the CD-ROM
drive.
4
From the Windows Start
menu, select "Run."
5
In the "Open" field of
the dialog box that
appears, enter
"Q:\Win98_Me\Setupinf
.exe" and click "OK."
* Enter the dri ve name Q: appropriate for the drive name of your CD-
ROM drive.
16
Q:\Win98_Me\Setupinf.exe
If the UM-2 is already
connected to your computer
and a message of "Add New
Hardware Wizard" is
displayed, go to the UM-2
Driver CD-ROM folder
named Win98_Me, open the
file Readme_e.htm, and
read the
"Troubleshooting" section
entitled "You attempted to
install using the above
procedure, but were not
able to."
The UM-2 cannot be used
with Windows95 or
Windows NT.
If you wish to use the UM-2
at the same time as another
USB device connected to
your computer, disconnect
the other USB device from
the USB connector before
installing the UM-2 driver.
If another USB device is
connected to your computer
when you install the UM-2
driver, the UM-2 driver may
not be installed correctly.
To check the drive name of
your CD-ROM drive,
double-click the My
Computer icon.