Edirol UM-2 Mode D'emploi page 12

Installing & Setup the Driver
11
Use the USB cable to connect the UM-2 to your
computer.
Near the task bar, your computer will indicate "Found New
Hardware". Please wait.
fig.2-6
12
The Found New
Hardware Wizard will
appear.
Make sure that the screen
indicates "EDIROL UM-2 ",
select "Install from a list or
specific location
(Advanced)", and click
[Next].
fig.2-7
13
The screen will indicate
"Please choose your
search and installation
options".
Select "Don't search. I will
choose the driver to
install", and click [Next].
fig.2-8_20
14
Make sure that the
"Model" field indicates
"EDIROL UM-2 ", and
click [Next]. Driver
installation will begin.
12
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
connecting a USB connector is
required before the unit will
operate normally.