en
ENGLISH
No trimming function
Transport lock activated:
pull out transport lock.
Safety lock activated:
loosen safety lock.
Cutting power too low
Saw blade blunt (possibly tempering marks on
blade body);
Saw blade unsuitable for the material (see
chapter 11. "Accessories");
Saw blade contorted:
Replace saw blade (see chapter 9.
"Maintenance").
Saw vibrates a lot
Saw blade contorted:
Replace saw blade (see chapter 9.
"Maintenance").
Saw blade not installed properly:
Install saw blade properly (see chapter 9.
"Maintenance").
Turntable hard to turn
Chips under turntable:
remove chips.
15. Technical Specifications
Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
U
= mains voltage / voltage of battery pack
I
= rated power
F
= min. fuse protection
P
= rated input power
1
IP
= protection class
n
= no-load speed
0
v
= max. cutting speed
0
D
= saw blade diameter (outer)
d
= saw blade hole (inside)
b
= max. tooth width of the saw blade
A
= dimensions (lxwxh)
m
= weight
Requirements for chip and dust extraction unit:
D
= connection diameter of the extraction
1
nozzle
D
= minimum air throughput
2
D
= minimum negative pressure at extraction
3
nozzle
D
= minimum air speed at extraction nozzle
4
Maximum cross-section of workpiece, see table
on page 4.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. Depending on the operating
conditions, the condition of the power tool or the
accessories, the actual load may be higher or
lower. For assessment purposes, please allow for
breaks and periods when the load is lower. Based
on the adjusted estimates, arrange protective
measures for the user e.g. organisational
measures.
Typical A-effective perceived sound levels:
L
= sound-pressure level
pA
L
= acoustic power level
WA
K
, K
= uncertainty
pA
WA
Wear ear protectors!
12