Norton Clipper CP512-300 Instructions D'emploi page 43

11.6 Length Of Coverage
Saint-Gobain Abrasives, Inc. to the initial owner and each subsequent purchaser that the engine is free
from defects in materials and workmanship which cause the failure of a warranted part for a period of
two (2) years.
11.7 What Is Covered
Repair or replacement of any warranted emissions part will be performed at no charge to the owner at an
approved Saint-Gobain Abrasives, Inc. servicing dealer. If you have any questions regarding your warranty
rights and responsibilities, you should contact your nearest authorized servicing dealer or call Saint-
Gobain Abrasives, Inc., at 1-800-554-8003 or www.nortonconstructionproducts.com.
Listed below are the parts covered by the emission components defect warranty.
Some of the parts listed below may require scheduled maintenance and are warranted up to the first
scheduled replacement point for that part.
• Fuel metering system
– Carburetor and internal parts
– Fuel filter, if applicable
– Throttle stopper, if applicable
– Choke system, if applicable
• Air induction system
– Air cleaner plate, air filter
– Air cleaner case, intake manifold
11.8 Diagnosis
The owner shall not be charged for diagnostic labor which leads to the determination that a warranted part
is defective, if the diagnostic work is performed at an approved Saint-Gobain Abrasives, Inc. servicing
dealer. However, if a warranty claim is made and the machine is tested as non-defective Saint-Gobain
Abrasives, Inc. will charge you for the cost of the emission test. Mechanical diagnostic will be performed at
an authorized Saint-Gobain Abrasives, Inc. servicing dealer. Emission testing may be performed at Saint-
Gobain Abrasives, Inc. or any independent emissions test laboratory.
11.9 Consequential Damages
Saint-Gobain Abrasives, Inc. may be liable for damages to other engine components caused by the failure
of a warranted part still under warranty.
11.10 Limitations
Any failures caused by abuse, improper maintenance, or neglect are not covered. Repairs or
replacements not conforming to Saint-Gobain Abrasives, Inc. specifications that affect the performance or
durability, or other modifications not approved in writing by Saint-Gobain Abrasives, Inc.
Saint-Gobain Abrasives, Inc. is not liable for any failures of warranted emission components caused by the
use of add on or modified parts.
11.11 How To Make a Claim
Bring the product to any Saint-Gobain Abrasives, Inc. authorized service center along with proof of
purchase. If you have questions regarding to how to make an emissions warranty claim or your warrant
rights you should contact the nearest authorized servicing dealer or call Saint-Gobain Abrasives, Inc., at
1-800-554-8003 or www.nortonconstructionproducts.com.
11.12 Maintenance Statement
The owner of this product is responsible for all required maintenance as stated in the operation manual.
Emission control warranty statement
• Ignition system
– Spark plugs
– Flywheel magneto
– Ignition coil
• Miscellaneous items used in the above
systems
– Fuel hoses
– clamps and sealing gaskets
ENGLISH 41