Sony STR-DA3200ES Mode D'emploi page 45

6
Press V/v repeatedly to select
"CAL TYPE," then press
enter the parameter.
7
Press V/v repeatedly to select
the parameter, then press
enter the selection.
Calibration Explanation
type
ENGINEER Sets the frequency
characteristics to a set that
matches that of the Sony
listening room standard.
FULL FLAT Makes the measurement of
frequency from each
speaker flat.
FRONT REF Adjusts the characteristics
of all the speakers to match
the characteristics of the
front speaker.
8
Press V/v repeatedly to select
"AUTO CAL START," then press
to start the measurement.
Measurement starts in five seconds. A
countdown appears on the TV screen.
While the time is counting down, stand
away from the measurement area to
avoid measurement error.
9
Measurement starts.
to
The measurement process will take
approximately 30 seconds. Wait until the
measurement process completes.
Note
to
You cannot measure the speaker height of the
surround speakers and the surround back speakers.
Set this value from "SP POSI." settings in the
Speaker Settings menu (page 71).
Tips
• Operations other than turning the receiver on or off
and pressing ON SCREEN to turn the display on or
off are deactivated during auto calibration.
• In the following situations, the measurements may
not be performed correctly or auto calibration
cannot be performed.
– when special speakers, such as dipole speakers
are used.
– when the multi zone function is used in zone 2.
To cancel auto calibration
Auto calibration is cancelled when you change
the volume, switch functions, change the
speaker setting of the receiver, or connect
headphones.
45 GB