Using A Bi-Amplifier Connection - Sony STR-DA3200ES Mode D'emploi

About the IR REMOTE jack
You can operate the receiver without pointing
the remote toward the IR sensor of the receiver
if you connect an IR repeater (not supplied) to
the IR REMOTE jack.
Use an IR repeater when you install the
receiver in a place where signals from the
remote cannot reach.
STR-DA3200ES
104
GB
Using a bi-amplifier
connection
If you are not using surround back speakers,
you can use the SURROUND BACK
SPEAKERS terminals for the front speakers
for use with a bi-amplifier connection.
IR repeater
To connect speakers
(not supplied)
Front speaker
RM-AAL003
Connect the jacks on the Lo (or Hi) side of the
front speakers to the FRONT SPEAKERS A
terminals, and connect the jacks on the Hi (or
Lo) side of the front speakers to the
SURROUND BACK SPEAKERS terminals.
Make sure that metal fittings of Hi/Lo attached
to the speakers have been removed from the
speakers. Not doing so may cause a
malfunction of the receiver.
To set up speakers
Set "SUR BACK SP" to "BI-AMP" in the
Speaker Settings menu (page 69). The same
signals output from the FRONT SPEAKERS
A terminals can be output from the
SURROUND BACK SPEAKERS terminals.
(R)
Hi
Lo
Front speaker
(L)
Hi
Lo