Using The Video Aux Jacks On The Front Panel; Connecting The Fm And Am Antennas; Connecting The Power Cable; Turning On And Off The Power - Yamaha HTR-6230 Mode D'emploi

Using the VIDEO AUX jacks on the
front panel
Use the VIDEO AUX jacks on the front panel to connect a
game console or a video camera to this unit. To reproduce
the source signals input at these jacks, select "V-AUX" as
the input source.
Caution
Be sure to turn down the volume of this unit and other
components before making connections.
Notes
• The audio signals input at the DOCK terminal on the rear panel take
priority over the ones input at the VIDEO AUX jacks.
• The audio signals input at the PORTABLE mini jack take priority over
the ones input at the AUDIO L/R jacks.

Connecting the FM and AM antennas

Both FM and AM indoor antennas are supplied with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
Notes
• The AM loop antenna should be placed away from this unit.
• A properly installed outdoor antenna provides clearer reception than an
indoor one. If you experience poor reception quality, install an outdoor
antenna. Consult the nearest authorized Yamaha dealer or service center
about outdoor antennas.
• The AM loop antenna should always be connected, even if an outdoor
AM antenna is connected to this unit.
Outdoor AM antenna
Use a 5 to 10 m (16 to 32 ft)
of vinyl-covered wire
extended outdoors from a
window.
ANTENNA
DEO
DVR MONITOR
N OUT
OUT
AUDIO
Ground
For maximum safety and minimum
interference, connect the antenna GND
terminal to a good earth ground. A good earth
ground is a metal stake driven into moist earth.
AM loop
antenna
(supplied)
Indoor FM
antenna
AM
(supplied)
GND
FM
R
SURRO
75
UNBAL.
OUTP
Connecting the wire of the AM loop antenna
Open the Insert
lever
Assembling the supplied AM loop antenna
Note
• The types of the supplied AM loop antenna is different depending on the
models.

Connecting the power cable

Once all connections are complete, plug the power cable
into the AC wall outlet.
L
To the AC wall outlet

Turning on and off the power

Turning on this unit
Press ASTANDBY/ON (or dPOWER) to turn on
this unit.
y
• When you turn on this unit, there will be a 4 to 5-second delay before this
unit can reproduce sound.
Set this unit to the standby mode
Press ASTANDBY/ON (or cSTANDBY) to turn
off this unit.
Note
• In the standby mode, this unit consumes a small amount of power in
order to receive infrared signals from the remote control.
Connections
Close the
lever
Power cable
15
En