Scsi-Bus Termination - External Tape Drives; Mounting The Internal Tape Drive - Tandberg Data SLR Serie Manuel D'installation Et Guide De L'utilisateur

Tandberg SLR Installation and User's Guide
SCSI-bus Termination - External
Tape Drives
If the Tape drive is the only device on the external SCSI-bus, it
must be terminated using the external SCSI termination
provided with the solution. See figure:
SCSI Host
Adapter
If other external device(s) is/are present, the
Tandberg SLR tape drive can be installed in any position on the
SCSI-bus, the SLR tape drive must be terminated if installed at
the end of the SCSI-bus. See figure:

Mounting the Internal Tape Drive

Wide/Narrow Configuration
All SLR internal tape drives can be connected either to a 16 bit
Wide SCSI or an 8-bit Narrow SCSI host adapter. SLR25 is
provided with an internal cable with a narrow connector. SLR7-140
internal tape drives are supplied with a WIDE connector. If you plan
to use SLR2-5 with a WIDE SCSI host adapter you will need a
Narrow SCSI host adapter Narrow to WIDE converter for the
internal cable supplied with your SLR2-5 tape storage solution. If
you plan to use SLR7-140 with a narrow SCSI host adapter you will
need a Wide to Narrow converter.
SLR Tape Drive (Must
be terminated)
Tandberg Data
15