Periodic Maintenance; Maintenance With Petrol Engine - Enarco QGH 25/45 Manuel D'instructions

2.-
required).
Therefore, the section chosen is equal to 4 mm
two verifications.
SECTION LINE mm
25
16
10
6
4
2,5
1,5
0 1000
NOMINAL INTENSITY X LINE LENGTH (A m)

4.3 PERIODIC MAINTENANCE

4.3.1 MAINTENANCE WITH PETROL ENGINE

1.-
reservoir with oil.
2.-
3.-
4.-
5.-
6.-
7.-
workshop for service accordingto the intensity of the usage.
8.-
danger.
9.-
adjusted at 3.000 rpm.
FIXED AND EXTENSIBLE VIBRATING SCREEDS
The permitted heating of the cable according to VDE standard (minimum transversal section table
I.e. For 10 A, according to table for 15 A or less, the section is of 1 mm
2
115 V 230 V
2000 3000 4000 5000
Daily (8 hours).
Clean the motor and the beams, check the bolts & nuts, check and fill the motor´s
Weekly (50 hours).
Change the motor oil (first 20 hours), clean the sparking plugs and the air filter.
Monthly (200 hours).
Clean the oil filter, clean and adjust the sparks plugs.
Every 500 hours.
Clean and set the carburattor, clean the cylinder´s head, set the valves.
Always use original parts by every maintenance operation.
The safety fittings have to be checked after every maintenance.
Every 12 months or more frequently, the screed has to be sent to an authorized
Do not fill the petrol reservoir while smoking or near any other potencial source of
Lock the petrol admission key when filling, use unleaded gas, clean the gas spelt.
Idle speed of the motor must not exceed 3.000 rpm. (standard set).
By every maintenance operation, the idle speed of the engine has to be checked and
See the motor´s manual to set the motor´s speed, starting and stopping.
2
, always chose the highest transversal section of the
Minimun section according VDE rules
2
Line (mm )
380 V
1
1,5
2,5
4
6
10
16
6000
25
Maximum (A) Max fuse (A)
15 10
18 10/3-16/1-
26 20
34 25
44 35
61 50
82 63
108 80
2
.
en
7
7