Specific Safety Rules - Enarco QGH 25/45 Manuel D'instructions

DISCONNECT the plug from the power source before making any adjustments, changing accessories,
or storing the tool.
STORE idle tools out of reach of children and other untrained persons.
MAINTAIN tool with care. KEEP cutting tools sharp and clean.
CHECK for misalignment or binding of moving parts, breakage of parts, and any other condition that
may affect the tools operation. If damaged, have the tool serviced before using.
USE only accessories that are recommended by the manufacturer for your model.
SERVICE
Tool service MUST BE PERFORMED only by qualified repair personnel.
When servicing a tool, USE only identical replacement parts.
FOLLOW instructions in the Maintenance section of this manual.

SPECIFIC SAFETY RULES

For your own safety, as well as for the other´s one and in order not to cause any damage to this
equipment, please read carefully the instructions that are explained as following:
FUTHERMORE, THE OPERATOR IS COMPELLED TO RESPECT ADDITIONAL REGULATIONS
ENFORCED
FIXED AND EXTENSIBLE VIBRATING SCREEDS
1.- For the proper use of this device, please assure that the operator has been correctly
informed of the content of this manual before using it.
2.- This screed can be used only under the applications for which it has been designed and
according to these safety instructions.
3.- Do not touch any part of the vibrating group when the motor is running.
4.- Do not work in an area exposed to flamable liquids or gases.
5.- Do not allow unexperienced or not trained personal to use the poker alone.
6.- Always keep the vibrating screed clean and dry.
7.- Please secure all the threads and bolts before working.
8.- Do not stop the screed until the concrete mass is fully vibrated.
9.- Do not work with the screed if any type of disfunction, even small, has been observed
until repair.
10.- When working with a petrol screed:
- Read the motor manufacturer's manual before working.
- Do not work in closed rooms, the exhaust fumes may be toxic.
- Wait 2 minutes for the petrol refill until the motor get colder.
11.- When working with an electric screed:
- Before connecting the motor to the power source, check that the Voltage and
Frequency match the specifications appearing in the plate.
- Make sure that the cables are of the correct section and are in good condition.
- If the screed is connected to a generator, please secure the Output and voltage
specifications are the convenient ones for the model as showed in the specifications plate.The
voltage do not varied more than 5%.
- Keep the air intake clean and open for the correct running of the motor.
12.- The accoustic power level of this machine can reach 92 dB (the accoustic pressure will
be 85,5 dB) Proper protective equipment should be used.
en
5
5